UHV Sample Heater - Resistive Type

300W single channel resistive UHV sample heater for UHV sample heating or effusion cell temperature control. Fully software controlled and web enabled.

The HEAT1-PS is used for UHV sample heating heating and/or thermal evaporator control. The unit is equipped with integrated PID temperature controller and controleld ramp power heating. The unit can be operated in AUTO mode (with temperature control) or MANUAL mode (without temperature control). Type-K and type-C thermoucouples are supported as well as silicon diodes for cryogenic systems.

It is suitable for UHV sample heating over the temperatures range 20degC to 1500 degC. The maximum temperature depends upon the exact details of the sample holder/evaporator. It operates equally as well with home made sample heaters or with any sample heater from our UHV sample holder range.

The unit is also fully software controlled and web-enabled so that it can be operated over any network, including the internet.

HEAT1-PS UHV Sample Heater:

Software Controlled & Web Enabled:

UHV Sample Heater Power Supply HEAT1-PS

UHV Sample Heater Power Supply Software HEAT1-PS

Heat1-PS UHV Sample Heater Specifications:
Supply voltage
110 or 230V, 50-60Hz, specify at time of order
Temperature range control
up to 1500 degC
Temperature ramp rate
0.1 degC/hr to 1000 degC/sec
Heater current ramp rate
0.1 to 10 A/min
Output power
300W (30VDC, 10A)
Regulation method
Integrated PID control
Thermocouple inputs (x2)
Type C or K
high vacuum pressure gauge
User interface
Large high brightness LCD alphanumeric
Dimensions19” rack mount or standalone

You may also be interested in the The Heat2-PS, our dual mode (resistive and electron beam) UHV sample heater.

Copyright © 2017 Henniker Scientific. All Rights Reserved.